Request Information Download PDF Configure Output Connector
GT-83083-0505-USB-W2E GT-83083-0505-USB-W2E
Level VI Power Supply / Charger, 5v, 1.0A, for Europe with integral USB Jack
Information
Model NumberGT-83083-0505-USB-W2E
DescriptionGT-83083-0505-USB-W2E, ITE Power Supply, Wall Plug-in, AC/DC Switching Adapter with USB Power Supply AC Adaptor, , Input Rating: 100-240V ̴ , 50/60Hz, European CEE 7/16 configuration: Europlug 2 PIN, Output Rating: 5 Watts, 5V in 0.1V increments, Approvals: CE Double Insulation GOST-R Level VI RoHS 2 Ukraine WEEE SIQ CB
Agency Documentshttp://www.globtek.info/certs/GT-83083-USB-W2Z/
CE EC-Declaration for MedicalContact GlobTek for more information
CE EC-Declaration for Industrial/Commercial/ITEhttp://globtek.force.com/models/ec_declaration?id=a0Oa000000MEmx4EAD
RoHS/RoHS3 Declarationhttp://www.globtek.com/pdf/rohs_cert/a0Oa000000MEmx4EAD
REACH Declarationhttp://www.globtek.com/pdf/iso_certificates/REACH.pdf
Conflict Minerals Declarationhttp://www.globtek.com/pdf/conflict-minerals.pdf
Model Parameters
TypeWall Plug-in
TechnologyAC/DC Switching Adapter with USB Power Supply AC Adaptor
CategoryITE Power Supply
Input Voltage100-240V ̴ , 50/60Hz
I/P Amps (A)0.2A
Wattage (W)5
Vout Range (V)5
EfficiencyVI
Ingress Protection
Size (mm)65.60*36.0*22.5 +/-0.5
EnclosureUser-added image

 
Rating Table
Model Number VoltageAmps (A)Watts (W) RFQ
GT-83083-0505-USB-W2E 515 RFQ
GT-83083-0506-USB-W2E 60.834.98 RFQ
Specifications01. Input Voltage: Specified 90-264 Vac, Nameplate rated: 100-240Vac
02. Input Frequency: Specified 47-63 Hz, Nameplate rated 50-60Hz
03. Output Regulation: +/- 5% measured at the output connector measured at the end of a 0.6 meter USB cordset employing #22 Gauge conductors
04. Line Voltage Regulation: +/- 1% typical measured at the output connector measured at the end of a 0.6 meter USB cordset employing #22 Gauge conductors
05. Output Ripple (Vp-p): +/-1% or 100 mV whichever is greater measured at the end of a 0.6 meter USB cordset employing #22 Gauge conductors. Measured at 20 MHz bandwidth with 0.1 uf ceramic capacitor in parallel with 10 uf electrolytic capacitor connected at the end of the output connector.
06. Inrush Current: at full load, 25°C, cold start
07. Switching Frequency: 100 KHz typical, varies with line and load
08. Efficiency: 73.77% minimum at nominal input voltage average, Efficiency meet CEC Ⅴ, ERP:2009/125/EC

B) PROTECTION
01. Over-current protection: 1.5A maximum with auto-recovery function
02. Over-voltage protection: 10VDC maximum with zener clamp
03. Short-circuit protection:The adapter shall not be damaged by short the DC output to Ground.

C) SAFETY
01. Dielectric Withstand Voltage: Primary To Secondary: 3000VAC 10mA 1minute or 4242VDC 10mA 1minute
02. Leakage Current: 20uA maximum, at nominal AC input voltage and frequency
03. ESD Immunity per EN61000-4-2, ±8 kV contact, ±15 kV air, Perf Criteria A Standard.

D) OTHER:
01. MTBF: 200,000 Hours @ 25°C ambient temperature
02. Operating Temperature: 0°C to 50°C ambient temperature
03. Operating Humidity: 20 ~ 85 % RH. non-condensing
05. Storage Temperature: -20°C to 60°C
06. Storage Humidity:5 ~ 95 % RH. non-condensing
07. Cooling: Cooling shall be with natural convection cooling
08. RoHS 2: Complies with EU 2011/65/EU China SJ/T 11364-2014

E) ENCLOSURE
01. Housing: High impact plastic, 94V0 polycarbonate, non-vented
02. Markings: Label and/or Pad Printed and/or Molded in the case
Derating Curve
Qty (ea.)/Carton360
Individual Box/Gift Box Size (mm)95(L)*54(W)*68(
Individual Box/Gift Box ColorWhite
Master Carton Size (mm)445 x 305 x 305
Gross Weight (kg)21.0
Label Width (mm)30.0
Label Height (mm)24.0
Input Configuration
DescriptionEuropean CEE 7/16 configuration: Europlug 2 PINThe prongs of the Europlug are 19 mm long. They consist of a 9 mm long conductive tip of 4 mm diameter with a rounded ending, followed by a 10 mm long flexible insulated shaft of not more than 3.8 mm diameter. The two prongs are not exactly parallel and converge slightly; their centres are 19 mm apart at the tip and 18.6 mm apart at the base. The elasticity of the converging prongs provides sufficient contact force for the Europlug's current rating with a variety of socket-hole arrangements. The entire plug is 35.3 mm wide and 13.7 mm high, and must not exceed these dimensions within 18 mm behind its front plane (this allows for the recesses on many European socket types). The left and right side of the plug are formed by surfaces that are at 45° relative to the horizontal plan.

User-added image
Output Configuration
Common output connector options:
Click to add to your request.






L Type (Coaxial 5.5x2.5mm plug) C Type (Coaxial 5.5x2.1mm plug) K Type (Coaxial 3.5x1.3mm plug) LL Type (5.5x2.5mm Locking 760k type) CL Type (5.5x2.1mm Locking S761k type) Magnetic Connector





YL3 Type (KPPX-3P) YL4 Type (KPPX-4P) EJ1/2/3/4/5 (EIAJ RC-5320A type connectors) MSB Type (Micro USB) Inquire for custom design

For a comprehensive list of options, click here

Contact GlobTek for your specific requirements or custom solutions.

Approvals
LogoDescription
User-added imageAttention Mark / Refer to operating manual for operating and service instructions

No Logo Applicable

CB report 60950-1 2nd Ed
User-added image  CE Mark: tested to comply with EN55022:2006/A1:2007 Class B, EN610003-2, EN610003-3 including EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6N EN61000-4-11; EMI: Complies with EN55011 CLASS B and FCC Part 15B - On label or Molded in case
User-added image

Double Insulation - Mark is on the label or Molded in the case
User-added image
 
GOST-R mark for Russia(Document: http://www.globtek.com/html/iso_certificates/GT_GOST-R.pdf). 03/15/2015. Due to lack of demand, GlobTek will not be renewing it's GOST certification. Please contact your sales engineer for pricing on EAC.
User-added imageIndoor Use Only - Mark is on the label or Molded in the case
 User-added image
 
Efficiency: complies to section 301 of Energy Independence and Security Act (EISA) complies with Energy Star tier 2 (North America), ECP tier 2 (China), MEPS tier 2 (Australia), Code of Conduct (Europe)
RoHSSpecifications of directive 2011/65/EU Annex VI (ROHS-2) with amendment 2015/863-EU (ROHS-3) http://www.ce-mark.com/Rohs%20final.pdf
User-added image
IEC/EN60950-1
SIQ Mark License EN60950-1
User-added imageUkraine UKRSepro (Document: www.globtek.com/html/iso_certificates/GT_Ukraine.pdf)
 User-added imageWEEE: Complies with EU 2012/19/EU (http://ec.europa.eu/environment/waste/weee/index_en.htm) Mark is on the label or Molded in the case
Popular Products
SKUVolts OutCurrent Out (Amps)Connector
19848651Type "A" USB “JACK”, integral to power supply enclosure
19848751Micro-B USB 5 Pin Type "B" or Equal
26248351Type "A" USB “JACK”, integral to power supply enclosure
25904751Type "A" USB “JACK”, integral to power supply enclosure
20569551Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
20569551Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
19848651Type "A" USB “JACK”, integral to power supply enclosure
News Releases
TitleWeb Link
Level VI Compliant Power Supply / Charger from GlobTek with Integral USB Jack and European Fixed Blade Offers 5Vo @ 1A!http://en.globtek.com/news/level-vi-compliant-power-supply-charger-from-globtek-with-integral-usb-jack-and-european-fixed-blade-offers-5vo-1a

Request Info

Text us your inquiry